What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 12:57

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
The bolt then partially travels down the line to your home.
2024–10–14 [Omar Gharbi Omar Gharbi ]
This Google experimental app lets you run powerful AI models without Wi-Fi - Android Police
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
It seems Mohan does not understand the difference between a comment and an Answer.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Because the load is inductive, the current lags the voltage.(by a bit).
This is 'the assistant's answer'
Here is a simplified AC power diagram.
Triassic reptiles took 10,000 mile trips through 'hellish' conditions, study suggests - Phys.org
The MOV will conduct when the voltage exceeds 50% of line voltage.
[image of Common-mode choke]
These devices are installed between the “hot” and “neutral” and protective ground.
This decades-old Gmail trick is still my favorite email management hack - Android Police
[old diagram got deleted by accident]
2024–10–10[John johnson John Johnson ]
what exactly is a ‘surge’ protector?
What is every dictators biggest fear?
One is “what exactly is in a ‘surge protector’ ? ”
What does a fuse do?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This Is How To Make Your Brain Act 4 Years Younger, According To Science - MindBodyGreen
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
One
the problem then depends on "how fast does the fuse operate?".
so, what happens?
These are simplified answers to the original question, and does not change anything I wrote above.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It also is a device that limits the change in current flow.
An AC voltage/ current source, and an ac inductive load.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Why didn't my ex fight for our relationship? He gave up so easily.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but this device (an Inductor) … impedes the rapid changes in the current.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At least they know the answer if they wanted it.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
eight
The third is lightning and “how it gets conducted into a home.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
a photo is worth a thousand words.
Upvotes:
Edit 2024–10.
A circuit breaker is similar, but is resettable.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
For this case there are devices called Metal oxide varistors (MOV).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But it can get overloaded, and no longer works.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
but I think this circuit , shows a few more pieces.
Barnstars:
I post the exact comment here.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
There are two important concepts here.
There are three different concepts here that are getting confused.
In schematic diagrams this is the symbol for a fuse:
This one hit behind the barn.
He then describes the function of a fuse.
He then asserts :
(Dc diagram shown, AC is similar).
This device then solves the entire problem.
This is where the MOV conducts again, and dissipated the energy.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
2024–10–16 [ OO OLAOYE OYEBODE ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What is lightning?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
But… the neutral is now “floating” because of the 1 ohm resistance.
nine
At one ohm, the resistor has a maximum of 1 watt power.
Now when you have a certain ac resistance, then a current flows in a loop.
The other is “what does a “fuse” do?”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
A fuse is a non-resetable over current circuit protector.
First Sentence:
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then describes Rainy Season and Lightning.